The INSTALL SETTING Menu

The INSTALL SETTING Menu

The INSTALL SETTING menu is used for changing the settings of the projector.

INSTALL SETTING

INPUT-A

 

KEYSTONE MEM: OFF

DIGIT KEYSTONE: 0

INSTALLATION: FLOOR-FRONT

CINEMA BLACK: ON

LAMP TIMER: 234h

KEYSTONE MEM

ON: DIGIT KEYSTONE setting is stored.

The data is retrieved when the projector power is turned on. The setting will remain the same every time.

OFF: DIGIT KEYSTONE is reset to 0 when the power is turned on the next time.

INSTALLATION

Sets to reverse the picture horizontally or vertically.

FLOOR-FRONT:The picture is not reversed.

CEILING-FRONT: The picture is reversed horizontally and vertically.

FLOOR-REAR:The picture is reversed horizontally.

CEILING-REAR:The picture is reversed vertically.

Note

In case of using a mirror, be careful of installation since the picture may be reversed.

CINEMA BLACK

Switches the lamp wattage during projection. OFF: Normal wattage.

ON: Enhances the black by reducing the lamp wattage.

Notes

•It will take a few seconds for the projector to change the lamp wattage during projection.

•If the CINEMA BLACK is set to ON, it starts with OFF when the power is turned on, then changes to ON after a while.

DIGIT KEYSTONE

Corrects the trapezoid caused by the projection angle. If the base edge is longer, set a negative value; if the upper edge is longer, set a positive value to square the image.

Note

If “ZOOM”, “FULL” or “NORMAL” have been selected in the ASPECT of the INPUT SETTING, you can change the trapezoid.

LAMP TIMER

Indicates how long the lamp has been turned on.

Note

This only displays the time. You cannot alter the display.

28 (GB)