To operate from the remote control

To turn on the radio, press RADIO ON/BAND•OFF for more than 1 second (while the tape is in stop mode only).

To select the band, press RADIO ON/BAND•OFF for more than 1 second while the radio is on.

To tune in or recall a preset station, press FF + or REW –. To turn off the radio, press

RADIO ON/BAND•OFF.

starts scanning the stations from the lower frequencies and stops for about 5 seconds when a station is received.

4If you wish to preset the currently received station, press ENTER while the preset number is flashing.

The received station is preset on preset number 1 and the unit starts scanning for the next receivable station.

5Repeat step 4 until all receivable stations are preset.

Presetting Radio Stations

You can preset up to 30 stations—20 for FM and 10 for AM (for the JPn area*, up to 16 stations—8 for FM and 8 for AM).

*Only if available. See “Receiving Stations Outside Japan”.

Presetting Automatically Scanned Stations

1Press RADIO ON/BAND to turn on the radio.

2Press RADIO ON/BAND repeatedly to select AM or FM.

3Press and hold ENTER for more than 3 seconds.

Preset number 1 will flash in the display and the main unit

To stop scanning

Press RADIO OFF. The radio is turned off at the same time.

Notes

•If stations are already stored, the newly preset stations replace the old ones when the above procedure is completed.

•If stations cannot be preset automatically, preset them manually.

Presetting Stations Manually

1Press RADIO ON/BAND to turn on the radio.

2Press RADIO ON/BAND repeatedly to select AM or FM.

3Press ENTER.

The frequency digits will flash in the display.

59