•Connection with all Bluetooth devices cannot be guaranteed.

–A device featuring Bluetooth function is required to conform to the Bluetooth standard specified by Bluetooth SIG, and be authenticated.

–Even if the connected device conforms to the above mentioned Bluetooth standard, some devices may not be connected or work correctly, depending on the features or specifications of the device.

–While talking on the phone hands free, noise may occur, depending on the device or communication environment.

•Depending on the device to be connected, it may require some time to start communication.

Others

•Using the Bluetooth device may not function on cellular phones, depending on radio wave conditions and location where the equipment is being used.

•If you experience discomfort after using the Bluetooth device, stop using the Bluetooth device

immediately. Should any problem persist, consult your nearest Sony dealer.

Maintenance

Replacing the lithium battery of the card remote commander

Under normal conditions, the battery will last approximately 1 year. (The service life may be shorter, depending on the conditions of use.)

When the battery becomes weak, the range of the card remote commander becomes shorter. Replace the battery with a new CR2025 lithium battery. Use of any other battery may present a risk of fire or explosion.

+ side up

c

Notes on the lithium battery

•Keep the lithium battery out of the reach of children. Should the battery be swallowed, immediately consult a doctor.

•Wipe the battery with a dry cloth to assure a good contact.

•Be sure to observe the correct polarity when installing the battery.

•Do not hold the battery with metallic tweezers, otherwise a short-circuit may occur.

WARNING

Battery may explode if mistreated.

Do not recharge, disassemble, or dispose of

24 in fire.

Fuse replacement

 

When replacing the fuse, be

 

sure to use one matching the

 

amperage rating stated on the

 

original fuse. If the fuse blows,

 

check the power connection and

 

replace the fuse. If the fuse

 

blows again after replacement,

 

there may be an internal

 

malfunction. In such a case,

Fuse (10A)

consult your nearest Sony

 

dealer.

 

Cleaning the connectors

The unit may not function properly if the connectors between the unit and the front panel are not clean. In order to prevent this, detach the front panel (page 6) and clean the connectors with a cotton swab dipped in alcohol. Do not apply too much force. Otherwise, the connectors may be damaged.

Main unit

Back of the front

 

panel

Notes

•For safety, turn off the ignition before cleaning the connectors, and remove the key from the ignition switch.

•Never touch the connectors directly with your fingers or with any metal device.