Southwing SH505 manual Introduction, Charging The Headset, USB Charging, Please Note

INTRODUCTION

Thank you for choosing a Bluetooth® product from SouthWing.

This user guide provides all the infor- mation you will need to use and care for your product.

All relevant information regarding your SouthWing product can be found on the support section of our website:

www.south-wing.com

1. CHARGING THE HEADSET

You will need to charge the battery of your Headset. To do so, follow these steps:

1.Plug the power supply into a power point.

2.Plug the connector of the power supply into the USB Charging Socket [1]. The Indicator Light [2] will turn red to indicate the Headset battery is charging.

3.Once the Indicator Light [2] turns off, the Headset is fully charged and can be removed from the power supply.

USB Charging

Thanks to its USB charging facility, the Headset battery can be charged from any USB port, such as those found on a PC or laptop, by using the USB cable adaptor accessory from SouthWing.

Please Note:

·The Headset will not function while charging.

·If the Indicator Light [2] remains off when charging, the battery is already fully charged

aand does not require further charging.

·To maximise battery life, do not charge the Headset for extended periods of time.

·Full battery capacity will be achieved after two or three full charge/discharge cycles.

·When your battery is flat, it takes up to four hours to completely charge your headset.

·For charging, only use power supply or

aaccessories approved by SouthWing.

2. PAIRING THE HEADSET

Auto-pairing

For added convenience, your headset has an auto-pairing function so that when you turn the headset on for the first time, it is already in pairing mode (you will also hear a series of high tones). Then, follow these steps:

1.Put the mobile phone into pairing mode (see the instructions which came with your phone). Ensure that the mobile phone is no more than 1 metre away from the headset

2.Enter the PIN number: 1111.

If pairing is successful, the Indicator Light [2] will begin flashing every 3 se- conds.

Normal pairing

You will need to follow the steps below if you want to pair your Headset with another mobile phone.

1.Ensure the Headset is off

2.Press and hold the On/Off Button [3] for about 5 seconds until the Indicator Light [2] flashes red and green alternatively (you will also hear a series of high tones)

Then complete normal pairing process by following point 1 and 2 of the auto- pairing section above.

Pairing with more than one device

You will be able to pair your Headset with up to 3 devices but only one devi- ce can be active at a time. If the

® Bluetooth is a registered trademark owned by Bluetooth SIG, Inc. U.S.A. and licensed to SouthWing.

3