SOYO SY-6BA+ III manual Power-On by Keyboard Jumper JP10, Power On, JP10 Setting

Hardware Setup SY-6BA+ III

Step 17. Power-On by Keyboard Jumper (JP10)

You can choose to enable the Power-On by Keyboard function by

shorting pin 1-2 on jumper JP10, otherwise, short pin 2-3 to disable

this function.

Power-On by		Enable	Disable
Keyboard
	Short pin 1-2 to enable		Short pin 2-3 and the
JP10 Setting	the Power-On by		Power-On by Keyboard
	Keyboard function.		function is disabled.

1 2 3

1 2 3

Note: When using the Power-On by Keyboard function, please make sure the ATX power supply can take at least 720mA load on the 5V Standby lead (5VSB) to meet the standard ATX specification.

Step 18. Power On

You have now completed the hardware installation of your Motherboard successfully.

1.Turn the power on

2.To enter the BIOS Setup Utility, press the <DEL> key while the system is performing the diagnostic checks,

Note: If you have failed to enter the BIOS, wait until the boot up sequence is completed. Then push the RESET button and press <DEL> key again at the beginning of boot-up, during diagnostic checks.

23