SOYO SY-6BA+ III manual Power Off, Suspend Mode

Hardware Setup SY-6BA+ III

Step 20. Power Off

There are two possible ways to turn off the system:

1.Use the Shutdown command in the Start Menu of Windows 95/98 to turn off your computer.

2.Press the mechanical power-button and hold down for over 4 seconds, to shutdown the computer. If you press the power- button for less than 4 seconds, then your system will enter into

Suspend Mode.

Note on Over-clocking Capability

The SY-6BA+ III provides over-clocking capability. Due to the over- clocking setting your system may fail to boot up or hang during run time. Please perform the following steps to recover your system from the abnormal situation :

1.Turn off system power (If you use an ATX power supply, and depending on your system, you may have to press the power button for more than 4 seconds to shut down the system.)

2.Set the JP8 to short if you use a FSB 66MHz CPU

3.Press and hold down the <Insert> key while turning on the system power. Keep holding down the <Insert> key until you see the message of the CPU type and frequency shown on the screen.

4.Press the <Del> key during the system diagnostic checks to enter the Award BIOS Setup program.

5.Select [SOYO COMBO SETUP] and move the cursor to the [CPU Frequency] field to set the proper working frequency.

6.Select [Save & Exit SETUP] and press <Enter> to save the new configuration to the CMOS memory, and continue the boot sequence.

Note: SOYO does not guarantee system stability if the user

over clocks the system. Any malfunctions due to over-clocking are not covered by the warranty.

28