Cisco Systems SPA9000 manual MAC Clone Settings section, Remote Management section

SPA9000 Field Reference

Router Tab

B

Secondary DNS	The DNS server that is used by the SPA9000
	NOTE When DHCP is enabled, you can enter the IP address
	of a DNS server in addition to DHCP-supplied DNS servers.
	When DHCP is disabled, enter the primary DNS server.
	Default: 0.0.0.0
DNS Server Order	The method for selecting the DNS server: Manual, Manual/
	DHCP, and DHCP/Manual
DNS Query Mode	The mode of DNS query: parallel or sequential
	NOTE With parallel DNS query mode, the SPA9000 sends
	the same DNS lookup request to all the DNS servers at the
	same time, and the first incoming reply is accepted by the
	SPA9000.
	Default: parallel
Primary NTP Server	The IP address or name of the primary NTP server
Secondary NTP Server	The IP address or name of the secondary NTP server
DHCP IP Revalidate
Timer:

Router tab > Wan Setup page >

MAC Clone Settings section

Enable MAC Clone	Enable if you need to assign a different MAC address to the
Service	SPA9000 via the Cloned MAC Address field.
Cloned MAC Address	The MAC address that you need the SPA9000 to assume

Router tab > Wan Setup page >

Remote Management section

Enable WAN Web Server	Allows (yes) or prevents (no) access to the administration
	web server from a computer that is not directly connected to
	the SPA9000.
	Default: yes
WAN Web Server Port	The port that is used for WAN access to the SPA9000
	Default: 80

SPA9000 Voice System Administration Guide 195