Cisco Systems SPA9000 manual Entering the Line Interface Dial Plan, Resetting the Control Timers

Configuring Phone Lines and Calling Routing Behavior	4
Configuring Dial Plans

Entering the Line Interface Dial Plan

This dial plan is used to strip steering digits from a dialed number before it is transmitted out to the carrier.

STEP 1 Connect to the administration web server, and choose Admin access with Advanced settings.

STEP 2 Click Voice tab > Line N, where N represents the line interface number.

STEP 3 Scroll down to the Dial Plan section.

STEP 4 Enter the digit sequences in the Dial Plan field. For more information, see “About Dial Plans,” on page 66.

STEP 5 Click Submit All Changes.

Resetting the Control Timers

You can use the following procedure to reset the default timer settings for all calls.

NOTE If you need to edit a timer setting only for a particular digit sequence or type of call, you can edit the dial plan. See “About Dial Plans,” on page 66.

STEP 1 Connect to the administration web server, and choose Admin access with Advanced settings.

STEP 2 Click Voice tab > Regional.

STEP 3 Scroll down to the Control Timer Values section.

STEP 4 Enter the desired values in the Interdigit Long Timer field and the Interdigit Short Timer field. Refer to the definitions at the beginning of this section.

SPA9000 Voice System Administration Guide 77