Cisco Systems SPA9000 manual Voice Setting, Calling Timers, Dialing Parameters

SPA400 Field Reference

Setup

C

Voice Setting

Calling Timers

Wait-for-Answer time	The time in seconds that the SPA400 waits for the called
	party to answer the call before terminating the call
	automatically
	The maximum value is 100 seconds.
	Default: 180
Call Limit	The maximum time that a call can continue before it is
	terminated automatically
	Default: 65535
Dialing Parameters
Tone out on	The duration in milliseconds of each tone in a DTMF
	sequence
	Default: 200
Tone out off	The number of milliseconds that elapses between
	successive digits in a DTMF sequence
	Default: 200
DTMF power	The power level in 0.1 dBm of the DTMF tones
	Default: -130
Answer after	The number of rings that occur before the SPA400 answers
	an incoming call
	The maximum value is 2 rings. Because the PSTN does not
	transmit caller ID information until after the first ring, this 2-
	ring setting is recommended to ensure that caller ID
	information is available.
	Default: 2
Dial out wait	The number of milliseconds that elapse after the SPA400
	seizes a telephony port and before the SPA400 sends DTMF
	digits
	Default: 400
Dial out battery	The minimum voltage level that the SPA400 must detect on a
threshold	telelphony port before seizing a telephony port for an
	outbound call
	Default: 20

SPA9000 Voice System Administration Guide 265