Cisco Systems SPA9000 Ring and Call Waiting Tone Spec section, Control Timer Values sec section

SPA9000 Field Reference

Voice tab

B

Voice tab > Regional page

Ring and Call Waiting Tone Spec section

Ring Waveform	Waveform for the ringing signal: Sinusoid or Trapezoid.
	Default: Trapezoid
Ring Frequency	Frequency of the ringing signal. Valid values are 10–100 (Hz).
	Default: 0
Ring Voltage	Ringing voltage. 60–90 (V).
	Default: 85
CWT Frequency	Frequency script of the call waiting tone. All distinctive CWTs
	are based on this tone.
	Default: 440@-10

Voice tab > Regional page

Control Timer Values (sec) section

Hook Flash Timer Min	Minimum on-hook time before off-hook qualifies as hook-
	flash. Less than this the on-hook event is ignored. Range: 0.1–
	0.4 seconds.
	Default: .1
Hook Flash Timer Max	Maximum on-hook time before off-hook qualifies as hook-
	flash. More than this the on-hook event is treated as on-hook
	(no hook-flash event). Range: 0.4–1.6 seconds.
	Default: .9
Callee On Hook Delay	Phone must be on-hook for at this time in sec before the
	SPA9000 tears down the current inbound call. It does not
	apply to outbound calls. Range: 0–255 seconds.
	Default: 0
Reorder Delay	Delay after far end hangs up before reorder tone is played. 0
	= plays immediately, inf = never plays. Range: 0–255
	seconds.
	Default: 5
Call Back Expires	Expiration time in seconds of a call back activation. Range: 0–
	65535 seconds.
	Default: 1800

SPA9000 Voice System Administration Guide 229