Cisco Systems SPA9000 manual PBX Parameters section, Default

SPA9000 Field Reference

Voice tab

B

EXT RTP Port Min	External port mapping number of the RTP Port Min. number. If
	this value is not zero, the RTP port number in all outgoing SIP
	messages is substituted for the corresponding port value in
	the external RTP port range.
	Default: blank
NAT Keep Alive Intvl	Interval between NAT-mapping keep alive messages.
	Default: 15

Voice tab > SIP page

PBX Parameters section

Field	Description
Proxy Network Interface	This setting tells the SPA9000 how the client stations are
	connected. Choices: {LAN, WAN}. The SPA9000
	communicates with client stations via the selected interface
	only.
	Default: WAN
	NOTE For optimum voice performance, Linksys Engineering
	and Quality Assurance recommend that only WAN is used.
Proxy Listen Port	Port at which the SPA9000 listens for client messages at the
	selected network interface. The proxy also sends SIP
	messages from this port.
	Default: 6060
Multicast Address	IP address (and port number) where the SPA9000 sends
	control messages to all the client stations at once. This must
	be a multicast address and must contain a port number.
	Default: 224.168.168.168:6061
Group Page Address	IP address (and port number) where the SPA9000 tells the
	client stations to send and receive group page RTP packets.
	This must be a multicast address and must contain a port
	number.
	Default: 224.168.168.168:34567
Max Expires	Sets the maximum allowed Registration expires value in
	seconds for client stations. Linksys recommends using a
	relatively small value, such as 60 or 120.
	Default: 60

SPA9000 Voice System Administration Guide 212