SOYO SY-P4VM800 quick start Features Setup, IRQ7

	SOYO SY-P4VM800 Quick Start Guide
BootToOS/2>64MB	Enable this item if you are booting the OS/2 operating
	system and you have more than 64MB of system
	memory installed.
AGPApertureSize	This item defines an AGP for the graphics. Leave this
	item at the default value 64MB.
DRAMTiming	This item allows you to enable or disable the DRAM
	timing defined by the Serial Presence Detect electrical.
Hyper-ThreadingFunction	If your P4 CPU is not HT CPU, this item will be hidden.
	If your P4 CPU is HT CPU, BIOS will show this item.
	You can set "Disabled" or "Enabled" to control HT CPU
	support in O.S. Set “Enabled” to test HT CPU function.
AutodetectDIMM/PCI	When this item is enabled, BIOS will disable the clock
Clock	signal of free DIMM/PCI slots.
SpreadSpectrum	Use this item to set the system bus spread spectrum for
	the installed processor.

3.6 Features Setup Page

Thispagesetsupsomeparametersforperipheraldevicesconnectedtothesystem.

CMOSSETUPUTILITY–Copyright(C)1985-2003,AmericanMegatrends,Inc.

CD

FeaturesSetup
OnBoardFloppyController	Enabled
SerialPort1Address	3F8/IRQ4
OnBoardIRPort	Disabled
ParallelPortAddress	378
ParrllelPortMode	ECP
ECPModeDMAChannel	DMA3
ParallelPortIRQ	IRQ7
OnBoardPCIIDEController	Both
OnBoardSATA-IDE	Enabled
AudioDevice	Enabled
ModemDevice	Auto
EthernetDevice	Enabled
OnBoardUSBFunction	Enabled
USBFunctionforDOS	Disabled

HelpItem

AllowsBIOStoEnableorDisable FloppyController.

The SOYO

↑↓←→ :Move Enter:Select +/-/:Value F10:Save Esc:Exit

F1:GeneralHelp	F9:OptimizedDefaults
OnBoardFloppy	Use this item to enable or disable the onboard floppy disk
Controller	drive interface.
SerialPort1Address	Use this item to enable or disable the onboard COM1/2
	serial port, and to assign a port address.
OnBoardIRPort	Use this item to enable or disable the onboard infrared port,
	21