SOYO SY-P4VM800 quick start Hard Disk Drive/Floppy Drive/CD-ROM Issues

SOYO SY-P4VM800 Quick Start Guide

Hard Disk Drive/Floppy Drive/CD-ROM Issues

22.My hard disk drive is not detected during Power Up Self Test routine.

Change the jumper settings of the hard drive to cable select or single.

23.Sometimes the system finds my CD-ROM, and sometimes not

1.Ensure the CD-ROM is working properly.

2.The power supply may not provide enough power for all installed devices. Remove all redundant devices, such a second hard drive/CD/DVD-ROM/RW, and reboot. If the system functions normally after the removal some power-consuming devices, there may be a need for a reduction in installed devices or for a more powerful power supply.

24.When I boot up my newly installed system, the monitor reads "Floppy Boot Failure" and the LED of the floppy disk does not go out.

1.Ensure the red wire of floppy ribbon cable goes to Pin1 on the floppy drive side (don't trust the "key lock" or "notch") and use the end-connector of the cable (don't use middle one).

2.Some floppy drivers have their own jumper to make the same twist as the twist on the cable. Ensure this jumper is set correctly.

Installation

Driver

Intel USB2.0

36

The SOYO CD