Star Manufacturing LC-4522 user manual Parking fanfold paper, Unparking fanfold paper

Parking fanfold paper 17

Parking fanfold paper

It is not necessary to remove fanfold paper currently loaded in the printer in order to print on cut-sheet paper. Instead, simply use the following procedure to park the fanfold paper.

o Tear off the paper at a perforation so there is no more than half a page sticking out of the front cover of the printer.

If necessary, you can press the control panel’s ON LINE button to put the printer off-line. and then use the LINE FEED button to feed the paper until a perforation isjust past the front cover.

o Press the control panel’s ON LINE button to put the printer off-line. o Press the control panel’s SET/EJECT/PARK button. The printer

automatically reverse feeds the fanfold paper until it is no longer in contact with the platen, which is indicated by the printer beeping a number of times. Also, the control panel’s POWER indicator starts to flash because paper is not loaded.

o Move the release lever to the cut-sheet position. o Change the paper guide to its upright position.

You can now load cut-sheet paper into the printer using the procedures under “Manual sheet feeding” on page 44.

Unparking fanfold paper

After you are finished printing on cut-sheet paper, use the following procedure to unpark fanfold paper and make it available for printing.

o Remove all cut-sheet paper from the printer.

o Move the paper guide so that it is at a lay down position: (Refer to page 10.) o Move the release lever to the fanfold position.

o Press the SET/EJECT/PARK button to feed the paper to the starting position.

The printer automatically goes back on-line at this time.