Initializing the printer | Star Manufacturing LC-4522 manual

Initializing the printer 27

Important!

Be sure to stop the print job before taking the printer off line. Otherwise, the print job will resume from where you interrupted it when you put the printer back on-line.

o Use ON LINE to take the printer off line (ON LINE indicator is not lit).

o Hold down PRINT MODE and then ON LINE. Keep both buttons held down until the printer beeps once, which indicates that the buffer is cleared.

Initializing the printer

The following procedure initializes the printer to its power-on settings. If you have control panel settings stored in memory, this procedure sets up the printer using them.

o Use ON LINE to take the printer off line (ON LINE indicator is not lit).

o Hold down PRINT MODE and then ON LINE. Keep both buttons held down until the printer beeps once (indicating the printer buffer is cleared) and

then beeps again three times, which indicates that the printer is reset.

Image 30

Star Manufacturing LC-4522 user manual Initializing the printer

Contents

LC-4522 Contents Using the EDS Mode Printer Setup Choosing a place for the printer Printer Setup Unpacking the printer General guide General guide Opening the front cover Removing the protective materials Removing the protective m aterials Installing the platen knob Installing the ribbon cassette Installing the ribbon cassette Removing the ribbon cassette Installing the paper guide Installing the paper guide Standing up the paper guide Connecting to a power outlet and turning power on and off Connecting to a power outlet and turning power on and off Loading fanfold paper Loading fanfold paper Printer Setup Loading fanfold paper Printing on fanfold paper Parking fanfold paper Unparking fanfold paperParking fanfold paper Using the tear-off function Connecting to your computerPage Switching between on-line and off-line Control Panel Operations Entering the Print Quality Lock Mode Selecting a Print QualitySelecting a font Entering the Multi-part Mode Form feed fanfold paper Line feedPaper eject cut-sheet paper Micro feed Setting the top of form position Selecting the Quiet Print ModeTear-off function fanfold paper Changing the auto load position Changing the auto load position Saving a macro Clearing the printer’s buffer Initializing the printer Initializing the printer About EDS Mode settings Entering the EDS ModeUsing the EDS Mode Selecting a bank Changing a switch settingSelecting a switch Selecting a bank Printing the current switch settings Exiting the EDS Mode EDS Mode Settings EDS Mode Settings Switches 1,2 Print mode Switch 6 Quiet modeSwitch 7 Not Used Switches 3, 4, 5 Print Pitch Switch 4 Skip over perforation Tractor mode only Switches 1,2 Multi-Part ModeSwitch 3 Auto Tear off Long Switch 5 FF command selection Friction mode only Switch 3 Zero Style Switch 1 Character TableSwitch 2 Character Set Switches 4,5 Reserved Switch 6 Print Width Switches 6,7 Not Used Switches 1,2,3,4 Page Length Friction ModeSwitch 5 Top Margin Switches 1,2,3,4 Page Length Tractor Mode Switch 3 CR Centering Position Switch 1 CR Centering at topSwitch 2 CR Centering at seem line Tractor mode only Switch 4 Paper Out Detector Switches 1, 2, 3, 4 International Character Set Switch 5 BuzzerSwitch 6 Print direction command Switch 5 Strobe timing Switches 1, 2, 3, 4, 5 Code Switch 6 Saving Control Panel Status Setting up for printing with MS-DOS Setting up for printing with MS-DOS Cut-Sheet Paper Manual Feed Selecting paper typesPaper Handling Cut-Sheet Paper with Optional Automatic Sheet Feeder Fanfold Paper Labels Adjusting for paper thickness Adjusting for paper thickness Automatic fanfold feeding Manual sheet feeding Clearing paper jams Clearing paper jams