ENGLISH
|
| Auto cutter | |
Lower | Paper insertion |
| |
paper |
| ||
slit | Upper paper | ||
| |||
| Paper insetion |
| |
| slit | Lower paper | |
Upper paper |
|
| |
| Print head | Platen | |
|
| ||
| Platen |
| |
| Print head |
|
Fig. 2-12 Insertion of the paper into the auto cutter
(When using copying paper) (SP347)
Paper outlet
Auto cutter
Fig. 2-13 Paper outlet of the front cover
(SP347)
CPull on the edge of the paper to remove any slack and then lower the
auto cutter.
DInsert the paper through the front
cover paper outlet and then replace the front cover by reversing the re- moval steps.
ETo install the rear cover reverse the removal steps.
2-3. Removing the Roll Paper
Remove the rear cover then cut off the paper near the rear of the paper guide. Then press the “FEED” switch to feed out the rest of the paper that is remaining in the unit.
When the paper runs out, a buzzer will sound four times per cycle for two cycles. NOTE 1. Press the “FEED” switch to remove the rest of the paper that is in
the printer. (If you remove the paper by hand, the paper could wrinkle or slip causing it to jam.)
NOTE 2. When the paper end mark appears on the paper, replace the roll paper before it runs out.
– 10 –
