Star Micronics NX-1001 manual usingthinnerpaper, Possibleremedy Selectthisoption

Check

Are you tryingto feed paper using the ffont panel buttons while the ON LINE indicator is illuminated?

Is the papertoothick?

Possible remedy

I

You can only feed paperin this way when theprinteris off-line. Set the printeroff-line andthen feed paper.

Thereprelimitsinthisto thethicknessofpaperthatcanbe fed way (one top copy and two NCRcopies)‘1. Try

usingthinnerpaper.

If the ASF is not operatingor is not feeding paper correctly, check the following:

Check

Has the ASF option been selected with the DIP switch?

he release lever set to the uosition?

1s- the ASF correctly mounted?

Is paper caught up neiw the printhead?

Are the left andright guides too close together?

Is theretoo muchpaperin the paperfeedhopperorstacker?

Was thepaperfannedbefore being fed into the ASF?

Has the paperbeen used al- ready or is it creased?

Are you tryingto feed paper using the frontpanel buttons while the ON LINE indicator is illuminated?

Is the papertoo thick or too ~in?

Possibleremedy

Selectthisoption.

Therelease lever should be set to the single-sheet I position.

MakesurethattheASFisproperly seatedontheprinter.

Stopprinting,remove thejarnmedsheet (you mayhave to remove the ASF for this), andcontinue.

If the left and right gui&s are too close together, the paperwill not feed smoothly.Move thema little further atmrtto allow the Dawr to feed ffeelv.

The ASF’Spaperfed hopperandstackercan hold 50 sheets each. Make surethatthereis no morepaperthan this in either the hoooer or stacker.

If this is not don%paperjams may occur. Remove the stack of paperfrom the ASF andfan it before reinsert- ilw.

Ordy new, uncressed paper should be used with the ASF.

You can only feed paperin this way when theprinteris off-line. Set the printeroff-line andthen feed paper.

Therearelimits to thethicknessofpaperthat cmbe fed in this way. Tryusing differentpaper.

93