Star Micronics NX-1001 manual Charactersdefinedby thiscommandcan be selectedby cES@ “I”

M	A				D			H
	<	“ c	n		27	36	0 nl	IB	26 00 nl
s	d	mO	ml	d	d	m		d	d
			m.?	. . . m46		m	... m		n ... m

Definesoneor morenewNLQ charactemand storesthemin RAM for later use. DIP switch 1-2 must be OFF. NLQ mode must be selectedbeforethis commandis executed.The parametersare the same as for the draftdownloadcharactercommandexceptthatthe attributebytespecifiesrightspaceinsteadofcharacterwidthandthe dot densityis doubledin each direction,so each characterconsists of 16 dotsverticallyand 23 dotshorizontallyand requires46 data bytes.Dotsdefinedby ml to m23areprintedon the firstpassof the head. Dotsdefinedby m24 to m46 are printedon the secondpass, the paperbeing scrolledup half a dot betweenthe two passes.For fimtherdetails,pleaserefer to the Chapter5.

M ADH

<	“	n	<	27 61 nl	n2	20	IB 3D nl	d	14
I	a	al d	ml	aO al	d	ml	aO al	d	ml
		d	... mll	d	... m		d	... m

Definesone or morenew draftcharactersand storesthemin RAM for later use. Draft modemust be selectedbeforethis commandis executed.nl and n2 givethe numberof databytesthat willfollow. tz(lis the charactercodeof the firstcharacterdefined.al anda2 are attributesbytes.ml to mll arethe characterdata,and arethe same as in <ESC> “&”. The attributebyte al indicates whether the characteris an ascender(not using the lowest of the nine vertical dots) or a descender(not usingthe highestdot) and whetherit has a downwardextensionto 12dots.

The attributebytea2 givesproportional-spacinginformation,Bit7 is ignored.Bits4 to 6 specifythe offsetto the first byte printed(O to 7), enablingleadingspacesin the characterto be ignored.BitsO to 3 specifythe widthof thecharactercell(maximum11dots).The characterwillbe followedby a mandatoryblankdotcolumnwhich is not includedin this width.

Charactersdefinedby thiscommandcan be selectedby cES@ “I”

4or cESC> “I” 5. This commandis ignoredwhenDIP switch 1-2 is ON.