14
ENGLISH
Removing jammed thermal paper
Use the following procedure to remove jammed paper from the thermal printing
mechanism whenever necessary.
❏Make sure that the printer is turned off and unplugged from its wall outlet.
❏Open the printer cover.
❏Pull up the receipt printer mechanism and swing it to a raised position until
it stops.
Important!
Parts of the receipt printer mechanism become very hot during printing. Be
sure to handle it carefully to avoid personal injury.
❏Press down on the green paper release lever to release the paper.
❏Pull the jammed paper out of the receipt printer mechanism towards the
back of the printer.
❏Cut off the damaged end of the roll paper.
❏Raise the green paper release lever and then reinsert the leading edge of the
paper into the receipt printer mechanism as described under “Loading
thermal roll paper” on page 9.
❏Gently lower the receipt printer mechanism back to its original position and
close the printer cover.
Adjusting the near-end sensor
A paper near end sensor detects when the thermal paper roll is getting near its
end and alerts you so you can get ready to replace the paper roll. Use the
following procedure to adjust the near-end sensor in accordance with the
diameter of the roll of paper you are using.
Important!
The printer is shipped from the factory with the near-end sensor disabled. You
can enable the near-end sensor by changing one of the printer’s memory switch
settings (See the separate Programmer’s Manual).
❏Make sure that the printer is turned off and unplugged from its wall outlet.