Syncing Process – cont’d
8.With the computer window still displaying “Conn” hold the magnet about 1/2 inch (1.2 cm) away from the edge of the cadence sensor with the large arrow pointing towards the magnet.
Wave the magnet back and forth several times until the window on the computer displays a random ID number (e.g. ID 45896).
Finally, accept ID by pressing the Toggle (right) button.
0. Once the Syncing Process is done, the display should be in the Workout Mode.
Wait for 60 seconds.
You must wait for 60 seconds to allow the computer to reset the ID prope
2.Test for response by turning the computer on then waving a magnet across the cadence sensor, as you did in the test on page 10. By doing this you are simulating the same m as when the flywheel rotates and the magnet passes by the cadence sensor. If you see displayed, then the cadence sensor and computer were synced successfully. Proceed w
the installation and mounting to the bike.
OTE: Remember to keep the computer and cadence sensor as a set at all times.
14
