Installation of Cadence Sensor and Magnet – All Spinners®
Before the cadence sensor is securely fastened to the flywheel support, it must be adjus so that it is about 5 mm (.20 in) from the magnet face. Install the magnet on the flywhee that it aligns with the arrow on the end of the cadence sensor. Note the distance betwee end of the cadence sensor and the magnet face. Remove the cadence bracket and adju the distance by pulling or pushing the cadence sensor bracket.
Tighten the set screw on the cadence mounting bracket using the M2 Allen tool
Caution
Do not over tighten the set screw.
Magnet location
Remove the backing of the adhesive on the magnet. Mount the magnet with the adhesiv tape side onto the flywheel by positioning the magnet so it will line up in front of the cade sensor as the flywheel turns. Note: Mount the magnet near one of the dots of the Spinn logo as shown in the figure above.
18
