10-Pump, 80-Station Controller Chapter 3: Installation 35
Figure 18: 4-Connector ArmorBlock Connections for Central Alarms
Alarm Silence Pushbutton (A-I0)
Alarm Silence Pushbutton (A-I1)
4 Input / 4 Output
ArmorBlock for
Central Alarms
Alarm Strobe Light (C-O0)
Alarm Horn (C-O1)
Alarm Silence Pushbutton (B-I2)
Alarm Silence Pushbutton (B-I3) Alarm Strobe Light (D-O2)
Alarm Horn (D-O3)
5. Dress the excess patch cord cables with cable ties so they do not interfere with
operation and to give a pleasing appearance.
3-5 Setup This section provides the procedures for configuring your 10-Pump, 80-Station
Controller. Configuration of your controller includes setting the number of stations and
pumps, setting variables such as convey time and blow-back interval, and setting up
passwords. We recommend that you carry out these procedures in the order given here.
Note: Before carrying out these procedures, install all equipment as
described in this section and in the Mechanical Components manual.
Figure below gives an overview of the basic flow between the menus used in setting up
the system.
Figure 19: Basic Menu Flow for Setup