10-Pump, 80-Station Controller Chapter 3: Installation 42
2. You can enter a name of up to four (4) alpha-numeric characters. If you would like
to enter a longer name, you can go back to the Station n Setup screen and press
Name Line 2 to repeat the process. Using Name Line 2 will allow you to
enter up to four (4) more alpha-numeric characters, for a total of eight (8) characters.
The characters will appear as two four-digit names on two separate lines.
Use ← to erase any mistakes. Use ↵ to enter the value.
Note: Make sure to choose different names, as the system does not recognize
duplicate names.
3. You can scroll through the stations by scrolling through Back and Next at the top
of the screen.
Copying Settings from One Station to Others
If other stations at your facility will use the same settings as a station you have already set up,
you can copy the settings from this station to the others. To do so:
1. At the Station n Setup screen (for the station you want to copy from), touch Copy in
the screen’s upper right.
The Station Copy screen appears, showing the station number for the station you are
copying from:
2. Follow the directions on the following pages to copy settings to one other station, a
range of stations, or all stations.
To copy the selected station’s settings to one other station
1. Touch the gray Copy to Station button next to the green button labeled Copy
To Single Station.
The keypad pops up.
2. Enter the station number for the station you are copying to. Use ← to erase any
mistakes. Use ↵ to enter the value.
The keypad disappears and the Station Copy screen shows the station number you
entered under Copy to Station.
3. Touch the green Copy to Single Station button.
“Copy Complete” briefly appears at the top of the screen.