10-Pump, 80-Station Controller Chapter 3: Installation 37
4. Press System Setup to return to the System Setup screen.
5. Touch Pumps Present in the upper part of the System Setup screen.
6. This will take you to the Pumps Installed screen.
The screen shows a list of pumps. The pumps that are not installed are red. The
pumps that are installed are green. Briefly touching the icon for a pump toggles
between not installed and installed.
7. Press System Setup to return to the System Setup screen.
8. The new setting appears under System Parameters on the System Setup screen.
Setting the Date/Time
You can set the current date and time by going to the System Setup screen and pressing Set
Time & Date.
1. To set the time, touch Hour. A keypad will pop up and you will be able to enter the
current hour. The controller uses military time. You can repeat this process for the
minutes by pressing Minute.
2. To set the date, touch Month. A keypad will pop up for you to enter the number of the
current month (i.e. May = 5). You can repeat this process to set the current day and year
by pressing Day and Year, as appropriate. Use ← to erase any mistakes. Use ↵ to enter
the value.
The keypad disappears and the new setting appears under Set Time &
Date.
Naming Purge Valves and Materials
You can assign purge valves and materials names rather than keep them assigned by
numbers. (You can name stations and pumps as well. Refer to the “Setting Up Stations” and
“Setting Up Pumps” sections later in this chapter).
1. Go to the System Setup screen and touch Name Purge Vlv/Material and scroll
through the list of purge valve/materials and find the one you want to rename.
2. Use the up and down arrows to select the purge valve/material you would like to name.
3. Select Press to Change at the bottom of the list.
A keypad will pop up.
3. You can then type in a name of up to eight alpha-numeric characters. Make sure to choose
different names, as the system does not recognize duplicate names. Use ← to erase any
mistakes. Use ↵ to enter the value.
Checking Addressing and Wiring for System Components
Once you have set the number of stations and pumps as described previously, you should
verify that the controller is communicating with all stations, pumps, and central alarms, and
with the ArmorBlocks for all central purge valves. To do so:
1. At the System Setup screen, touch DeviceNet Nodes on the right side of the
screen.
The DeviceNet Status screen appears: