English
Mounting the guide bar
1
2 | KN | |
2011BA051 | ||
|
NTurn the screw (1) counterclockwise until the tensioner slide (2) butts against the left end of the housing slot.
3
4 | KN | |
2011BA052 | ||
|
NFit the guide bar over the stud (3) and engage the peg of the tensioner slide in the hole (4).
Fitting the chain
WARNING
Wear work gloves to protect your hands from the sharp cutters.
1
2011BA053 KN
NFit chain around the sprocket (1) and over the guide bar – the cutting edges on top of the bar must point to the bar nose.
2 | KN |
| 2011BA054 |
NTurn the tensioning screw (2) clockwise until there is very little chain sag on the underside of the bar – and the drive link tangs are engaged in the bar groove.
3006BA028 KN
NRefit the chain sprocket cover – the pivot pin on the hand guard must engage the guard on the engine housing – and then screw the nut onto the stud fingertight.
NGo to chapter on "Tensioning the Saw Chain"
20 | MS 150 TC |