English
Saw chains with humped drive link (2) – upper part of the humped drive link (2) (with service mark) is lowered at the same time as the depth gauge of the cutter.
WARNING
The rest of the humped drive link must not be filed; otherwise, this could increase the tendency of the chain saw to kick back.
689BA051 KN
NRework the depth gauge so that it is flush with the file gauge
689BA044 KN
NAfterwards, dress the leading edge of the depth gauge parallel to the service mark (see arrow) – when doing this, be careful not to further lower the highest point of the depth gauge
WARNING
Depth gauges that are too low increase the kickback tendency of the chain saw.
689BA052 KN
NLay the file gauge on the saw chain
– the highest point of the depth gauge must be flush with the file gauge
NAfter sharpening, clean the saw chain thoroughly, removing any filings or grinding dust – lubricate the saw chain thoroughly
NIn the event of extended periods of disuse, store saw chains in cleaned and oiled condition
Sharpening tools (special accessories)
Chain pitch | Round file ^ Round file | File holder | File gauge |
Taper square file Sharpening set 1)
Inches | (mm) | mm | (Inches) | Part number | Part number | Part number | Part number | Part number |
1/4 P | (6.35) | 3.2 | (1/8) | 5605 771 3206 | 5605 750 4300 | 0000 893 4005 | 0814 252 3356 | 5605 007 1000 |
1/4 | (6.35) | 4.0 | (5/32) | 5605 772 4006 | 5605 750 4327 | 1110 893 4000 | 0814 252 3356 | 5605 007 1027 |
3/8 P | (9.32) | 4.0 | (5/32) | 5605 772 4006 | 5605 750 4327 | 1110 893 4000 | 0814 252 3356 | 5605 007 1027 |
0.325 | (8.25) | 4.8 | (3/16) | 5605 772 4806 | 5605 750 4328 | 1110 893 4000 | 0814 252 3356 | 5605 007 1028 |
3/8 | (9.32) | 5.2 | (13/64) | 5605 772 5206 | 5605 750 4329 | 1110 893 4000 | 0814 252 3356 | 5605 007 1029 |
0.404 | (10.26) | 5.5 | (7/32) | 5605 772 5506 | 5605 750 4330 | 1106 893 4000 | 0814 252 3356 | 5605 007 1030 |
1)consisting of file holder with round file, taper square file and file gauge
42 | MS 150 TC |