SERVICING INSTRUCTIONS
REPLACING PARTS
9.GAZCO FLUE SURE SYSTEM
9.1• Open the door and remove the ceramics, placing them carefully to one side.
•Undo the two screws in the back of the firebox and carefully withdraw the bracket, Diagram 14 and 15
14
AR1442
15
AR1446
9.2• Disconnect the two sensor wires
•Undo the two taptite screws
•Remove the sensor and the two plastic spacers, Diagram
16
16
AR1452
9.3• Refit the new sensor ensuring the plastic spacers are located between the bracket and the sensor
• Refit the leads
9.4• Feed the cable back through the hole as you replace the bracket.
When the bracket is located correctly it sits flush with the back panel without force. If not positioned correctly the bracket sits at an angle, Diagram 17
17
AR1447 | AR1448 |
10.PRIMARY AERATION PLATE
10.1Turn to Section 3.8 Removing the Door, in the Installation Section of this manual.
•Remove the door and place to one side
•Remove the cover plate from the bottom of the stove by undoing the screws, Diagram 18
18
AR1924
•Undo the M5 nyloc nut from the bottom of the burner unti and remove the aeration plate, Diagram 19
20
