INSTALLATION INSTRUCTIONS
INSTALLATION
IMPORTANT: ENSURE THAT THE APPLIANCE IS CORRECTLY ADJUSTED FOR THE GAS TYPE AND CATEGORY APPLICABLE IN THE COUNTRY OF USE. REFER TO DATABADGE AND TECHNICAL SPECIFICATIONS AT THE FRONT OF THIS BOOKLET.
FOR DETAILS OF CHANGING BETWEEN GAS TYPES REFER TO SERVICING SECTION, REPLACING PARTS
1.CONTROL UPGRADE
1.1This stove is fitted with a control valve that can be easily upgraded to battery powered remote control. There are two versions of this control which can be obtained through your local Gazco stockist.
1.2This upgrade can be fitted before or after installation but if side clearances are limited then it will be easier to upgrade the stove before installation. Full instructions are included with the kit.
1.3STANDARD REMOTE CONTROL This remote control can control the gas appliance after the pilot has been lit. It can turn the main burner on and regulate it from low through to high and back again. It can turn the main burner off leaving the pilot burning. GAZCO PART NUMBER 8455.
1.4THERMOSTATIC AND TIMER REMOTE CONTROL This remote control can control the gas appliance after the pilot has been lit. In ‘MANUAL MODE’ it can be used to turn the main burner on and manually regulate it from low through to high and back again. It can also be used to turn the main burner off leaving the pilot burning. In ‘AUTO MODE’ it will automatically regulate the room temperature. In ‘TIMER MODE’ it will turn the fire on and off according to a
2.SAFETY PRECAUTIONS
2.1This appliance must be installed in accordance with the rules in force, and used only in a sufficiently ventilated space. Place read these instructions before installation and use of this appliance.
2.2All the instructions must be left intact with the user.
2.3In your own interest, and those of safety, this appliance must be installed by a competent person in accordance with local and national codes of practice. Failure to install the appliance correctly could lead to prosecution.
2.4This appliance is intended for use on a governed gas installation and set to the required pressure.
2.5Keep all plastic bags away from young children.
2.6Do not place any object on or near to the stove. Allow adequate clearance above the stove. See diagram 2 page 9.
2.7The stove is fitted with the Gazco Flue Sure System, which cuts off the gas supply to the stove in the event of incorrect flue operation. If the system shuts off the gas supply, this indicates there is insufficient flue pull. If this happens, a
minimum of 10 minutes must be allowed before trying to relight. If this safety device is continually shuts off the gas it can suggest a serious problem:
• Contact Gazco
2.8Do not alter or tamper with the Flue Sure System. Use only genuine Gazco replacement parts when servicing the system - refer to the Servicing Section, Replacing Parts.
3.INSTALLATION OF THE STOVE
3.1Flue Pipe Installation
•Open the carton
•Remove the accessory carton and stove unit
•Decide whether to use top or rear flue exit
The stove is factory built for rear flue exit but it can be changed to top exit by swapping the flue spigot and blanking plate located on the stove.
3.2• Position the stove ensuring all appropriate clearances are observed
3.3Having run the gas supply to the stove:
• PURGE THE SUPPLY PIPE
This is essential to expel any debris that can block the gas controls.
•Connect the gas supply to the
There is a cutout in the
3
AR0934
3.4• Check the pull of the flue system by applying a lighted smoke pellet to the flue system opening
If there is a definite flow into the chimney, proceed with the installation. If not, warm the chimney for a few minutes.
IF THERE IS STILL NO DEFINITE FLOW, THE FLUE MAY REQUIRE ATTENTION - SEEK EXPERT ADVICE
10
