Stovax Huntingdon 30 manual User Instructions, General, Lighting The Stove, Upgrading Your Stove

USER INSTRUCTIONS

1.GENERAL

1.1A competent person must carry out installation and servicing.

1.2In all correspondence, please quote the appliance type and serial number, which can be found on the databadge located on a plate under the appliance.

1.3Ensure that curtains are not positioned above the appliance and there is at least 300mm between the sides of the appliance and any curtains.

1.4If any cracks appear in the glass panel do not use the appliance until the panel has been replaced.

1.5This product is guaranteed for 2 years from the date of installation, as set out in the terms and conditions of sale between Gazco and your local Gazco dealer. Please consult with your local Gazco dealer if you have any questions. In all correspondence always quote the Model Number and Serial Number.

1.6Any combustible shelves or surrounding furniture must only be fitted in accordance with the minimum dimensions detailed in diagram 1.

1

150150

225

853

AR0552

1.7Contact a competent service engineer to carry out relevant spillage checks etc. following home improvements carried out after installation of this stove (e.g. the fitting of double glazing).

2. LIGHTING THE STOVE

2.1 The control valve is at the foot on the right-hand side of the fire. It has two controls:

• The right-hand knob controls the pilot ignition

• The left-hand knob controls the main burner

2.2 Refer to separate instructions if your fire is upgraded to include battery remote control. The instructions below apply whether or not you have the remote upgrade.

Lighting the Pilot

2.3The left-hand and right-hand control knobs must both point to off ( ):

2

AR0914

•Press in the right-hand control knob and rotate anti- clockwise until a click is heard

•Continue to press in. The knob points to the pilot ( ). The pilot is lit

•Keep the knob depressed for 10 seconds before releasing. The pilot remains lit.

•Repeat the above steps if the pilot does not stay lit

NOTE: If the pilot goes out, the Interlock system prevents you lighting again for a short period

2.4If, after repeating the above steps the pilot does not light, contact your Retailer or Installer.

2.5Turn the right-hand knob to the left to main burner ( )

Adjusting the Flame height

2.6You can now adjust the flame height and temperature using the left-hand control knob:

•Turn the left-hand knob anti-clockwise to increase the flame height

•Turn clockwise to decrease the height

YELLOW FLAMES APPEAR WHEN THE FIRE HAS REACHED SUFFICIENT HEAT – (10 TO 20 MINUTES).

IF THE FIRE IS EXTINGUISHED OR GOES OUT IN USE, WAIT 3 MINUTES BEFORE TRYING TO RELIGHT.

MINUTES. 3. TURNING THE STOVE OFF

3.1To turn the main burner out:

•Turn the left-hand knob until it points to off ( ).Just the pilot remains lit.

•Press in and turn the right-hand knob until it points to off ( ). The pilot goes out.

4.UPGRADING YOUR STOVE

4.1Your stove is fitted with a control valve that can easily be upgraded to battery powered remote control. This upgrade can be fitted by anyone capable of simple DIY jobs and requires no special training. There are two versions of this control which can be obtained through your local Gazco stockist.

4