INSTALLATION INSTRUCTIONS
INSTALLATION
2.7The flue can now be cut to size. Measure the thickness of the wall, then deduct 12mm. This is the length required when measuring from the line on the flue label. See diagram 3.
3
AR0630
6
A
AAR1338
2.8Attach the flue to the appliance and seal using the aluminium tape. See diagram 4.
4
AR1335
2.9Place the sealing ring over the flue and position it up against the rear of the appliance. See diagram 5.
5
AR1336
2.10Fit the appliance on to the wall bracket by engaging the arms on the bracket into the slots in the rear of the appliance. See diagram 5.
2.11Fit the appliance as far back as possible and refit the two screws to secure the Linea to the wall bracket.
2.12Fit the lower two wood screws through the rear of the appliance and into the wall. See diagram 6 arrow A.
DO NOT OVER TIGHTEN. DO NOT DEFORM THE REAR OF THE APPLIANCE.
2.13Remove the nine screws retaining the glass frame, remove the frame and store in a safe place. See diagram 7.
7
AR1339
2.14Remove the cardboard packaging from on top of the burner and ensure the burner is fully engaged on the injector. Also check the burner retention spring is located over the stud and tab on the left hand side of the burner. See diagram 8.
8
AR1340
13
