Stovax PR0731 manual Servicing Instructions, Replacing Parts, Ignition Lead, magnetic safety valve

SERVICING INSTRUCTIONS

REPLACING PARTS

8

C

AR1994

7.3Undo the thermocouple nut in the back of the pilot burner by half a turn. This will release the thermocouple.

7.4When replacing the thermocouple into the pilot burner ensure the component is pushed fully into the hole. There is a stop on the thermocouple to set the height.

7.5Lock the retaining nut just enough to grip the thermocouple.

7.6Replace the lower panel.

8.IGNITION LEAD

8.1Remove the lower panel and pull the ignition lead off the electrode.

8.2Release the wires from the central white clip and carefully cut the cable ties. This will release the ignition lead. See diagram 9, Arrow B.

9

B

AR1994

8.3Replace with a new lead, replace with new cable ties and fit the wires back into the clip.

8.4Re-fit the panel and ensure no wires are trapped.

9.magnetic safety valve

9.1• Turn the gas off at the isolation device.

9.2• Remove the lower panel, Diagram 6

9.3• Undo the thermocouple from the interrupter block and remove the two thermo current cables

•Unscrew the interrupter block from the back of the valve.

Diagram 10

10

AR1994

9.4Support the valve and remove the magnetic valve retaining nut, Diagram 11

11

AR1994

9.5Reassemble in reverse order and check for gas leaks.

10.main injector

10.1Remove the lower panel. See diagram 6.

10.2Remove the glass frame. See diagram 12 arrow C.

20