SERVICING INSTRUCTIONS
REPLACING PARTS
12
| C |
|
|
|
|
|
|
|
|
| C | ||
|
|
|
|
|
|
|
| ||||||
| C |
|
|
|
|
|
|
|
|
|
| ||
C |
|
|
|
|
|
|
| C | |||||
|
|
|
|
|
| ||||||||
|
|
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
| C | |||
|
|
|
|
|
| C |
|
|
|
|
|
| |
|
|
|
|
|
|
| C |
|
|
|
| ||
|
|
|
|
|
| C |
| AR1338 | |||||
10.3Remove the main burner as described in section 2.
10.4Remove the locknut from the injector. See diagram 13
13
AR1345
10.5 Remove the feed pipe from the gas valve. See diagram 14.
14
AR1994
10.6 Remove the feed pipe with the injector attached from the
appliance. Note the orientation of the injector on the pipe.
10.7Reassemble in reverse order and check for gas leaks.
11.control box
11.1Remove the lower panel, Diagram 6
11.2Press on/off switch retaining clips in and pop put the switch. Turn the switch to pass it through the retaining bracket.
11.3Remove the two screws holding the control box to the bracket. Slide the control box to the right and remove from the bracket.
11.4• Remove the two thermo current cables by removing the two screws, Diagram 15
• Remove the eight loom wire from the control box,
Diagram 15
15Eight wire cable
Thermo current cables
Touchpad extension 
cable
Battery extension cable
AR1915
•Remove the battery extension cable, Diagram 15
•Remove the touch pad extension cable, Diagram 15
The control box can now be replaced.
11.5After replacing the control box you may need to reprogram the handset:
•Press and hold the reset button on the control box until you hear two signals. After the second longer signal:
•Release the reset button and within 20 seconds
-Press the DOWN button on the handset until you hear an additional long signal confirming the new code
•Refer to Section 4 of the Installation Instructions to set new code
21
