Stow 20HP STOW CUTTER 3 CE SAW - RULES FOR SAFE OPERATION, General Safety, Diamond Blade Safety

STOW CUTTER 3 CE SAW — RULES FOR SAFE OPERATION

General Safety

■ALWAYS read, understand, and follow procedures in Operator's Manual before attempting to operate equipment.

■ALWAYS be sure the operator is familiar with proper safety precautions and operating techniques before using the saw.

■NEVER leave the machine unattended while running.

■Block the unit when leaving or when using on a slope.

■ALWAYS check to make sure that the operating area is clear before starting the engine.

■Maintain this equipment in a safe operating condition at all times.

■ALWAYS stop the engine before servicing, adding fuel and oil.

■NEVER run the engine without the air filter. Severe engine damage could occur.

■ALWAYS service air cleaner frequently to prevent carburetor malfunction.

■AVOID wearing jewelry or loose fitting clothing that may snag on the controls or moving parts, this can cause a serious injury.

■ALWAYS keep clear of rotating or moving parts while the saw is in operation.

■ALWAYS store equipment properly when it is not being used. Equipment should be stored in a clean, dry location out of the reach of children.

■ALWAYS keep the work area well organized.

■ALWAYS clear the cutting area of any debris, tools, etc.that would constitute a hazard while the saw is in operation.

Diamond Blade Safety

■Use appropriate steel centered diamond blades manufactured for use on slab saws.

■Examine blade flanges for damage and excessive wear.

■Ensure the cleanliness of the blade before blade is installed. Blade should fit snugly on the shaft and against the inside/ outside blade flanges.

■Ensure the blade is marked with an operating speed greater than the blade shaft speed of the saw.

WARNING

ALWAYS inspect diamond blades before each use. The blade should exhibit no cracks, dings, or flaws in the steel centered core and/or rim. Center (arbor) hole must be undamaged and true.

WARNING

Only cut the material that is specified for the diamond blade. Read the specifications of the diamond blade to ensure the proper tool has been matched to the material being cut. The saw has been engineered for WET CUTTING. Ensure a WET CUTTING blade is being used and that the water supply system to the blade is properly functioning and being used.

■ALWAYS keep blade guards in place. Exposure of the diamond blade must not exceed 180 degrees.

WARNING

ALWAYS check to make sure that the operating area is clear before starting the engine.

■No one other than the operator is to be in the working area when the saw is in operation.

■Always observe all applicable compulsory regulations relevant to environmental protection, especially, fuel storage, the handling of hazardous substances, and the wearing of protective clothing and equipment. Instruct the user as necessary, or, as the user, request this information and training.

■Ensure that the diamond blade does not come into contact with the ground or surface during transportation. DO NOT drop the diamond blade on ground or surface.

■The engine governor is designed to permit maximum engine speed in a no-load condition. Speeds that exceed this limit may cause the diamond blade to exceed the maximum safe allowable speed.

■Ensure that the blade is mounted for proper operating direction.

■Adhere to the Blade Manufacturer's recommendations on handling, storage, and safe usage of blades.

PAGE 10 — STOW CUTTER 3 CE SAW — PARTS & OPERATION MANUAL — REV. #5 (09/22/06)