Stow 13HP, 20HP manual Engine ON/Off Switch Engine

STOW CUTTER 3 CE SAW — MANUAL START-UP (13HP HONDA ENGINE)

Figure 24. Engine ON/Off Switch (Engine)

3.Ensure the diamond blade has been mounted correctly and that it is raised above the surface you are about to saw.

4.Ensure the water tank is filled to capacity (18.95 liters/5 gallons). Connect the water tank hose to the water system brassfittingontherearoftheconsole(Figure18)andtestfor adequate water flow to the diamond blade before operation. When ready to start cutting, turn the water on.

5.Place the fuel valve lever (Figure 25) to the ON position.

Figure 25. Fuel Valve Lever

6.Place theEngine ON/OFFswitches(Figures 23 and 24) to the ON position.

The CLOSED position of the choke

lever enriches the fuel mixture for

NOTEstarting a COLD engine.The OPEN position provides the correct fuel mixture for normal operation after starting, and for restarting a warm engine.

7.If operating the Cutter 3 CE in cold weather conditions, skip this step and proceed to step 8. Place the ChokeLever (Figure 26) in the OPEN position. Skip to step9.

Figure 26. Choke Lever (Open Position)

8.If operating the Cutter 3 CE in cold weather conditions, placethe ChokeLever(Figure27)intheCLOSEDposition.

Figure 27. Choke Lever (Closed Position)

CAUTION

The engine governor speed has been set at the factory. Changing the governor speed could damage the blade and/ or the saw.

9.Place the throttle lever(Figure 28) halfway between FAST and SLOW for starting. All sawing is done at full throttle. The

engine governor speed is factory set to ensure optimum blade operating speeds.

STOW CUTTER 3 CE SAW — PARTS & OPERATION MANUAL — REV. #5 (09/22/06) — PAGE 27