Stow 13HP, 20HP manual Stow Cutter 3 CE SAW Maintenance

STOW CUTTER 3 CE SAW — MAINTENANCE

Figure 55. Pulley Alignment

Figure 57. Blade Side Bearing (Right Side)

Figure 56.V-Belt Alignment
Blade Shaft Bearing Replacement	Figure 58. Pulley Side Bearing (Left Side)

Although the steps for this operation are listed here, it is recom- mended that this procedure be performed by an authorized ser- vice center.

The Cutter 3 CE saw is supported by “tapped base lock collar (w/set screw)" self-aligning Blade Shaft Bearings (Figures 57 and 58). These heavy duty bearings support the 1-1/4 blade shaft, and have grease (zerk) points conveniently located for service.

1.Replacebothleft&rightbearings.Neverreplaceoneandnot theother.

2.Follow steps 1 thru 4 of Drive V-Belt(s) Replacement & Tension Adjustments.

3.Remove DriveV-belts.

Reference Figure 57 & Figure 58 for steps 4-9

4. Remove Blade Hex Nuts (Figures 57 & 58, item 1) and

Outside/Inside Blade Flanges (Figures 57, item 2 & 3)

5.Loosen set screws (Figure 58, item 4) and slide Pulley (Figure 58, item 5) off the Blade Shaft. Loosen Bearing set screw,removeBearingBolt(Figure58,item6)andslidethe BladeShaft Bearing(Figure 58, item 8) off the blade shaft.

6.Loosen set screws (Figure 57, item 5), remove Bearing Bolt (Figure 57, item 4) and slide the Blade Shaft Bearing (Figure 57, item 6) off the blade shaft.

7.Replace Blade Shaft Bearings and reassemble the Blade ShaftAssembly.

8.Re-tension Drive V-belts as shown in the Drive V-Belt(s) Replacement & Tension Adjustments section.

10. Replace all guards and covers.

STOW CUTTER 3 CE SAW — PARTS & OPERATION MANUAL — REV. #5 (09/22/06) — PAGE 39