Stow 20HP, 13HP manual Stow Cutter 3 CE SAW Major Components

STOW CUTTER 3 CE SAW — MAJOR COMPONENTS

Figure 3. Cutter 3 Major Components

Figure 3 displays the location of the various operational control features of the Cutter 3 Saw.Features are dependent on the specific model saw selected. The function of each console component or indicator is explained below:

1. Handle Bars – Used to steer and push the Cutter 3 saw during cutting operations. The handle can be folded down for transportation.

2.Forward/Reverse Speed Lever – Controls forward and reverse speeds for self-propelled operation. Provides positive neutral for engine start. ALWAYS place transmission engage/disengage lever in the engage position before setting speed lever (self-propelled models only).

3.Raise/Lower Crank Handle – Physically orients saw (raises or lowers) depending on cranking direction (CW or CCW). Turning the handle clockwise lowers the saw, turning the saw counter-clockwiseraises the saw.

4. Transmission Engage/Disengage Lever – Forward locking position engages transmission. Rear Locking position disengages transmission from rear axle and permits "free wheeling" (self-propelled models only).

5. WaterTank – A 5-gallon capacity water tank provides water for the saw blade during wet cutting applications.

6. Water ON/OFF Valve – ON position opens valve and permits water to flow from source through saw water hose. OFF position closes valve and halts the flow of water.

7. Hydraulic Drive Transmission - Controls the saw's forward and reverse movement by using the forward/ reverse speed lever (Self-propelled units only).

8. Saw Blade Guard – Covers the saw blade during cutting operations & allows water hoses to be connected to the cover for wet cutting.

9. Belt Cover – Covers the drive shaft belt, engine pulley and the hydraulic transmission belt (on self-propelled models only).

10. Drive-Shaft Pulley Guard – Covers the drive shaft pulley.

11. Rear Wheels – Allows the saw to be rolled across ground. On self-propelled models, the rear wheels are turned by the spline gears attached to the hydraulic transmission system.

12. Pointer Arm – Front pointer wheel assists in straight tracking. Lifts up for storage and pivots down for use.

13. Lifting Bale Kit – Allows for easy lifting and transporting the Cutter 3 Saw.

14. Engine OFF Switch – Toggle in either direction to stop the engine.

15.Wheel Clamp – Move handle down making contact with wheel to avoid unwanted rolling movement. Lift handle to release.

16.Throttle Lever – (self-propelled units only) Used to adjust engine RPM speed (SLOW or FAST).

PAGE 14 — STOW CUTTER 3 CE SAW — PARTS & OPERATION MANUAL — REV. #5 (09/22/06)