Stow 20HP, 13HP manual Throttle Lever, Starter Grip

STOW CUTTER 3 CE SAW — MANUAL START-UP (13HP HONDA ENGINE)

Figure 28. Throttle Lever

10.Grasp the starter grip (Figure 29) and slowly pull it out.The resistance becomes the hardest at a certain position, corre- spondingtothecompressionpoint.Pullthestartergripbriskly and smoothly for starting.

CAUTION

zDO NOT pull the starter rope all the way to the end.

zDO NOT release the starter rope after pulling. Allow it to rewind as soon as possible.

Figure 29. Starter Grip

11.Iftheenginehasstarted,slowlyreturnthechokelever (Figure 22) to the CLOSED position. If the engine has not started repeat steps 7 through 10.

12.Before the saw is placed into operation, run the engine for several minutes. Check for fuel leaks, and noises that would associate with a loose guard and/or covers.

13.All sawing is done at full throttle. Your engine governor has been set at the factory to ensure an optimum speed setting.

PAGE 28 — STOW CUTTER 3 CE SAW — PARTS & OPERATION MANUAL — REV. #5 (09/22/06)