Stow STOW CUTTER 3 CE SAW - ELECTRIC START-UP 20HP HONDA ENGINE, Choke Lever Open Position

STOW CUTTER 3 CE SAW — ELECTRIC START-UP (20HP HONDA ENGINE)

The CLOSED position of the choke

lever enriches the fuel mixture for

NOTEstarting a COLD engine.The OPEN position provides the correct fuel mixture for normal operation after starting, and for restarting a warm engine.

6.Place the throttle lever(Figure 35) halfway between FAST and SLOW for starting.

Figure 32. Engine Start Switch (OFF Position)

3.Ensure the diamond blade has been mounted correctly and that it is raised above the surface you are about to saw.

4.If operating the Cutter 3 CE in cold weather conditions, skip this step and proceed to step 5. Place the ChokeLever (Figure 33) in the OPEN position. Skip to step 6.

Figure 33. Choke Lever (Open Position)

5.If operating the Cutter 3 CE in cold weather conditions, place the ChokeLever(Figure 34) in theCLOSEDposition.

Figure 34. Choke Lever (Closed Position)

OR

Figure 35. Throttle Lever (Fast Position)

7.Rotate the Engine Shutdown switch (Figure 36) to the START position to engage the starter.

Figure 36. Ignition Switch (Start Position)

8.Once the engine has started, slowly return the choke lever (Figure 34) to the CLOSED position. If the engine has not started repeat steps 4 through 7.

9.Before the saw is placed into operation, place the throttle lever in the FAST position and run the engine for several minutes. Check for fuel leaks, and noises that would associ- ate with a loose guard and/or covers.

10.All cutting is done at FULLTHROTTLE.Your engine gover- nor has been set at the factory to ensure an optimum speed setting.

PAGE 30 — STOW CUTTER 3 CE SAW — PARTS & OPERATION MANUAL — REV. #5 (09/22/06)