Stow 20HP, 13HP manual Stow Cutter 3 CE SAW Inspection Belts & Water Tank

STOW CUTTER 3 CE SAW — INSPECTION - BELTS & WATER TANK

3.Check V-belt tension (Figure 17) by using a tensionmeter (2.7 - 4.1 kg/6.0 - 9.0 lbs.) against the inside belt at a mid point between the two pulleys, or by deflecting the center belt at a mid point 10 mm (3/8”) - 13 mm (1/2”).

Figure 17.V-BeltTension

4.DO NOT over or under tension the V-belts. Severe damage can occur to the saw and engine crank shaft if the belts are over tensioned. A decrease of power to the blade and poor performance will result if the belts are under tensioned (loose on pulleys).

Water Tank

The Cutter 3 saw is equipped with a removable 5-gallon on- board water tank fitted in the top of the console which can be connected to the brass hose fitting on the rear of the operators console (Figure 18).

Before using the water tank, ensure it is filled to capacity and connected to the hose fitting to provide lubrication during cutting. An external water source can also be connected to the CUTTER 3 for extended wet cutting operations.

5. If theV-belts becomes worn or loose, replace them by using	Figure 18. On-board Water Tank Hose Connection
the following V-belt part numbers listed in Table 6.

Table 6. V-Belts and Pulleys

Engine Size	Saw Type	Blade Size	V-Belt P/N	Engine	Blade Shaft
			(Qty.)	Pulley P/N	Pulley P/N
13 HP	Push	20 inch	16052 (3)	23665-001	25172-003
Engine	Self-Propel			23703-003	25172-003
20 HP	Self-Propel	20 Inch	15897 (4)	28833-002	23280-001
Engine

PAGE 24 — STOW CUTTER 3 CE SAW — PARTS & OPERATION MANUAL — REV. #5 (09/22/06)