S U B - Z E RO MODELS 315I A N D 315IP

INSTALLATION

S I D E PA N E L S

With Model 315I(P), you must securely fasten the side panels to the adjacent cabinets and floor.

Panels should be fastened to the floor and walls using ’L’ brackets (hardware not provided). To help you move the unit into place, rout out an area in the floor so the ‘L’ bracket will sit flush with the floor level. Brackets and screws are provided for mounting the unit to adjoining cabinets and side panels.

R E V E R S E T H E D O O R S W I N G

The hinged side of the door may be reversed to the other side if desired.

The Model 315I(P) is shipped with the door hinged at the right. The door and hinges are designed for placing the hinges on either the right or the left side of the unit. Moving the hinges to the left in the pre-drilled holes, allows the door to pivot from the left side. Refer to the illustrations below.

IMPORTANT NOTE: The plastic molding which covers the top area of the door, packaged with the ice maker, is required for this procedure.

I N S TA L L AT I O N

1)Remove the hinge cover.

2)Remove the door by removing the four screws that secure the door to the door hinges.

3)Remove the door hinges by removing the four screws that secure them to the unit.

4)Remove the four screws from the opposite hinge side (or left-hand hinge mounting holes) and reposition into the right-hand hinge mounting holes.

5)Install the hinges using the left-hand cabinet mounting holes.

6)Install the door using the left-hand door mounting holes.

7)Remove the two screws which secure the upper door panel mounting bracket.

8)Install the upper door panel mounting bracket using the left-hand mounting holes.

9)Install the left-hand door hinge cover with the original screws.

10)Check the operation of the door by opening and closing it.

Right-hand door swing

Left-hand door swing

 

Dimensions in parentheses are in

10

millimeters unless otherwise specified.

Page 10
Image 10
Sub-Zero 3 1 5 I P manual D E Pa N E L S, V E R S E T H E D O O R S W I N G, S Ta L L At I O N