Sub-Zero 3 1 5 I P manual I T I a L S TA RT- U P E C U B E S, E S to R a G E B I N, N T I M E

S U B - Z E RO MODELS 315I A N D 315IP O P E R AT I O N

ICE MAKER O P E R AT I O N
I N I T I A L S TA RT- U P		I C E C U B E S
1)	Remove the control box cover.	The ice cubes are tapered cylinders about 11/4"
2)	Rotate timer shaft clockwise until the cam is	(32) in diameter at the widest end; taper down
		to 1" (25) wide at the top; and are 11/8" (29)
	in the harvest position (switch button out).
		high. When the ice maker is adjusted properly,
3)
	Turn on the water supply.	there should be a 1/4" (6) indent in the base of
4)	With unit plugged in, rotate the ice maker	the cube. The ice will appear wet when fresh
		and may also develop frost on the outside and
	control knob to the ON position.
		look cloudy. This is normal. The frost will
5)	Allow the ice maker to operate for one hour,
		disappear when liquid is poured over the ice.
	and check the size of the cubes; if they are
	not correct, adjust as recommended on	I C E S TO R A G E B I N
	page 18.
6)	After the cubes are confirmed to be the	All restaurant-type ice makers, such as the
	correct size, replace all panels.	Model 315I(P), operate on this principal: The
		ice storage bin is not refrigerated; instead it’s
U S I N G YO U R I C E M A K E R		heavily insulated, much like a picnic cooler or
		ice chest. If the ice storage bin were to be
The ice maker is extremely simple to use; by		refrigerated, the ice would freeze together into
		one very large cluster of ice and would begin
turning the ice maker control knob to the ON
		to evaporate. This would yield ice that is very
position. The Model 315I(P) will automatically
		poor in quality and difficult to remove from the
begin to produce ice and will continue to do so
		ice maker.
until the ice storage bin is full.
Use the scoop to remove ice and place the ice		The Model 315I(P) will continue to operate
		until ice builds up high enough to contact ther-
scoop in the holder provided (do not leave the
		mostat sensor tube in the ice storage bin; then
scoop on the ice, as it will gradually disappear
		it will shut off. Models with a drain pump will
into the ice).
		occasionally pump out melt water when the ice
The Model 315I(P) will release a batch of eight
		maker is off. The pump will only be on for a
ice cubes about every 30 minutes. At the same		few seconds.
time the cubes fall into the ice storage bin,

water will be entering the ice maker and

draining out.	R U N T I M E
IMPORTANT NOTE: Do not store anything in	The amount of time the Model 315I(P) will run
	to replace melted ice is about two hours per
the ice storage bin other than ice; items like
	day. The amount of time the ice maker will run
wine or beer bottles are not only unsanitary,
	to replace ice removed is dependent upon how
but labels may also slip off and plug the drain.
	much ice is removed, how clean the ice maker
	is, the surrounding air temperature and the
	temperature of the water supplied to the ice
	maker. An empty ice maker will usually take
	about 24–36 hours to refill.

15