－ 43－ | Subaru Robin Power Products RGV12100, 13100T instruction

Attach the connectors to the brush holders. Connector the green wire to the stator end and the brown wire to the bearing end.

Install the brush cover.

(5)(RGV13100T only)

Attach the end cover to the rear cover.

(6)Tighten the nuts over the mount rubber bolts to fix.

Tightening torque

120 -140 kg cm

11.8-13.7 Nm 8.7-10.1 ft lbs

Fig. 9-12

NOTE : When tightening the nuts, slightly lift the alternator assembly so that the weight is not applied to the mount rubbers.

(7)Fasten the earth cable to the unpainted bolt hole on the frame.

EARTH CABLE

Fig. 9-13

－ 43－

Image 46

Subaru Robin Power Products RGV12100, 13100T service manual － 43－

Contents

Generators Contents － 04－ Specifications － 1－ Performance Curves － 2－ General Description of Generator － 3－ Control Panel － 4－ Serial Number － 5－ Stator Construction and Function－ 6－ Current Transformer RotorBrush / Brush Holder Diode Unit RGV13100T only ECU Electronic Control Unit 5 A.V.R Automatic Voltage Regulator RGV12100 only－ 8－ Idle Control Unit RGV12100 only － 9－ Relief Valve OIL Pressure SwitchAC Switch NO-FUSE Breaker － 10－ RGV13100T AC Receptacle－ 11－－ 12－ AC plug Description Gfci Receptacle Connecting to Domestic Circuit House Wiring－ 13－－ 14－－ 15－ AC Three Phase Receptacle RGV13100T only － 16－ Voltage Regulating Mechanism RGV12100 Description of Generator OperationPrimary Exciting Action RGV12100 － 17－ Advantages of Current Transformer Control RGV13100T Current Transformer Control RGV13100T－ 18－ Operate the generator on a level surface Safety PrecautionsDo not place inflammable materials near the generator Do not operate with wet hands or in the rain Motor driven tools and light electrical appliances Incandescent lamp, heater, etc. with a power factorRange of Applications － 20－ Appliances without any indication as to power consumption － 21－－ 22－ Measuring Instruments Measuring Procedures－ 23－ AC Output Measuring － 24－ Stator Measuring Insulation Resistance－ 25－ Current Transformer RGV13100T RotorControl Panel － 26－ AC Receptacles Checking Functional MembersPilot Lamp and Voltmeter － 27－ RGV12100 － 28－ Exciting Coil RGV12100 only Rotor Assembly－ 29－ Automatic Voltage Regulator BrushA.V.R － 30－ Current Transformer RGV13100T only － 31－ RGV12100 only Idle Control Unit－ 32－－ 33－ Disassembly Procedures Control Panel Disassembly and AssemblyPreparation and Precautions Alternator Component Parts － 35－ Generator assembly Control Box RGV12100 Control Box RGV13100T Fuel Tank Generator Assembling Procedures Front Cover － 40－－ 41－ Rear Cover － 42－－ 43－ AC Voltage is too high or too low Check engine speed TroubleshootingNo AC output Check if engine is overheated Engine dose not run － 45－ Wiring Diagram － 46－－ 47－ Lively Blvd. Wood Dale, IL 60191 Phone 630-350-8200 Fax