Subaru Robin Power Products RGX240D, RGX180 manual Order

1 Order 1	item	1			Procedure
4	Brush holder		( 1) Remove the brush cover.
!			Remove	the	brush cover in the back of
			the rear	cover.
			40 screw		. 2 pcs.

I (2) Remove the brush holders. (See Fig. 10-10.)

Disconnect the terminals wired to the brushes before removing the brush holders.

56 screw 2 pcs.

Remarks, Tool

1 ( + j screwdriver

1Be sure to remove the

brush holders first be- ! cause if the rear cover 1s removed from the gen- erator without removing the brush holders. the

I brushes will break.

		I
5	Rear cover	i 1) Loosen	the	cover bolts and remove
		them
		4~	bolt.	3 pcs.

!

(2)Remove the stator cover.

Turn up the stator cover edge and

Iremove the stator cover.

’t.31 Remove the rear cover. (See Fig. 10-l 1.)

Lightly tap the rear cover with a plastic hammer. and remove it.

I

,I

The type that uses a con- nectar does not permit complete separation of the stator and rear cover because the connector

icannot be pulled out of the rear cover or grom- met. In this case. simply

remove the rear cover ’ from the bearing.

1Omm spanner or box spanner

i.-) screwdriver

,

!

Fig. lo- 70 Fig. 10-71

- 44 -