Subaru Robin Power Products RGX180, RGX240D manual Tighten the cover bolt

3)Install the rear cover to fit the rotor bearing.

Lightly strike the circumference of the rear cover evenly with a plastic hammer. (See Fig. lo- 22.)

NOTE: Be careful not to pinch the wires between the stator and rear cover.

Fig. lo-22

3)Tighten the cover bolt.

NOTE: The bolt cannot be tightened unless the front cover and rear cover are positioned correctly. The shape of the cover bolt is shown below.

		Model	d	I	1		1	s
					90mm		’	15mm
			6mm	j
		RGX180	i					0.54	in.
			0.24in.	1	3.54	in.
		RGX240	6.3 mm		100 mm			15mm
		RGX240D	0.24 in.		3.94	in.		0.54	in.
r=	I	,	Table	10-2

Install the stator cover.

Fit the stator cover between the stator and cover bolts until it covers all the cover bolts. and fold back -:he edge.

Passthe wires out of the top of rear cover through the grommet. and fit the grommet into the hole in the rear cover. (See Fig. 10-X .i Then. reverse the bushing for mountmg the control box and place it on the grommet. The bushing has a larger diameter than the grommet.

Fig. lo-23

- 49 -