2> Install the generator in the frame.
Lift the generator with a chain b!ock. install it in the
Dame. and tighten the nuts. (See Fig.
8Qnuts. . _ . . . . . . . .4pcs.
Fig.
3)Attach the side plates to the frame.
&fount the side plate that reads “Robin Generator Model” to the front, and the blank side plate to the rear.
NOTE: Use the black bolts for tightening them.
50 x 13 mm bolts . . .8 PCS.
4)Attach thcr box stay to the side plates.
6ox 15mmbolts |
| . . . .Ipcs. | ||
60 | washer . . | _ | .Z PCS. | |
6o | spring washer | . _ . .2 | PCS. | |
6onut . . . | . | . . . . .2 | pcs. |
10
11 Fasten the control box to the frame and box stay.
NOTE: Spacers must be placed between the frame and
controi box. (See Fig.
68 x 15 mm bolts . | .3 | pcs. |
6~ washer . . . | . .4 | pcs. |
6~ spring washer . . . | 4 pcs. |
Attach the control box to the frame in |
| |
the control box. | I | |
I | ||
Refer to Paragraph | Fig. | |
box. | ||
|
2)NYre the primary exciting crrcuit.
Connect the two yellow wires of the automatic volt- age regulator in the control box to the exciting coil wires of the
INSERT
Fig.
- 52 -