Subaru Robin Power Products RGX180, RGX240D manual 10-3-3STATOR

10-3-3 STATOR

Install the stator to tit the faucet joint of the front cwer.

If it does not fit properly. lightl>- strike the stator cnre \vltil a plasti,_ hammer as shown in Fig. 1O-19.

NOTE: Never strike the winding.

NOTE: Make sure that the wires to the control box areup and that the wires to the brushes are to the back. (See Fig. 70-78.)

y., ta COYTROL BOX

STATOR

:cj BRUiti liOL%R

VER

I

STACY [

WIRES)1

I

I

Fig. lo-19

Fig. IO-18

10-3-4 REAR COVER

1)Install the diode stackin the rearcover.(See Fig. 10-20) 39 x 12 mm screw. . . 1 pc.

NOTE: Solder an assembly of leads, of the colors that

meet the specifications of the circuit diagram, and a

connector, to the diode stack.

DIODE

Fig. IO-20

LThe diode has markings of input ( -J, positive (-) and negative (-j, on this side. Two (5) leads are blue; (+ J orange; and (-j brown.

Fig. 70-21

3)Pass the wires Lvhich connect to the control b~,x from the stator through the hole in the top of the rear co~r.

- 48 -