Sun Microsystems 1800

Chapter 2 Hardware Installation 15

FIGURE2-3 SupportRail and Fixings (19-inch Rack)

The mounting screws should be placed in position pairs E1 and F1, E2 and F2, E3

and F3, E4 and F4 or E5 and F5. The pair of holes to be used depends on the front-

to-back depth of the rack (mounting flange to mounting flange). The holes marked

with the appropriate figure, as shown in TABLE2-2, should be closest to the rear of

the chassis.

The slots labeled G are used for mounting the rear flanges(see FIGURE2-6 on

page17). Only one of the vertical pairs of holes in the rear flanges should be used.

The spacers must be placed with the flat side towards the chassis and the

countersink towards the support rail (see FIGURE2-4).

TABLE2-2 Support Rail Screw Hole Locations

Rackdepth Screwholes

480 mm E5 and F5

530 mm E4 and F4

580 mm E3 and F3

630 mm E2 and F2

680 mm E1 and F1

E5E4E3E2E1

F4F3F2F1

Spacer (340-5483)

Spacer

Contents

Main Please Recycle Contents Page Page Page Figures Page Tables Page Preface Who Should Use This Book How This Book Is Organized Related Books What Typographic Changes Mean Shell Prompts in Command Examples Symbols Note Caution Caution Page Before Installation Note Electrical Supply Considerations Environmental Considerations Dimensions Airflow Consideration when Mounting in the Equipment Frame Page Page Page Mechanical Considerations when Mounting in the Equipment Frame Caution Mounting Requirements Loading Vertical space Note Depth Safety Hardware Installation Unshipping and Mounting the System Caution Note Tools Page To Unship and Mount the System Caution Mounting Flanges 19-inch Mountings Page Page The rear flanges are used to mount the chassis in the rearof the rack as shown in Page 23-inch, 24-inch and 600mm Mountings Page Page Page Cable Bracket Assemblies Removing and Installing Modules Caution Module Injector/Ejector Mechanisms To Remove a Module CPUset Modules Caution Page Page Page Page To Replace a Module Replacing an RMM To Remove the RMM Page To Replace the RMM Replacing a Disk Chassis To Remove the Disk Chassis Caution Page Page Flexible Module Cabling Page Page CAF External I/O Connections System Console Terminal Connections Note System consoles can be connected only to the CAF module. Modem Port Connections The modem port pinout is described in TABLE2-6. Alarms Port Connections The alarms port pinout is described in TABLE2-7. Page Electrical Supply Installation Note System Switch Note DC Source Site Requirements Overcurrent Protection Requirements Page Page Page Required Connection Materials Caution DC Supply and Ground Conductor Dual Grounding Environment Caution To Connect the Ground Lead Page Connecting the Power Leads Note To Assemble the Power Inlet and Leads + + Page Caution Powering on the System To Power On the System Note Page Software and Operating Environment Installation Netra ft 1800 Install Media Disk Space Requirement Installation Methods Note Local Installation Note Network Installation Before YouStart Caution To Install the Software Note Page Page 5.1 Finishing Installation 5.1.1 Setting up Access to Netra ft 1800 CMS Utilities 5.1.2 Setting the MANPATH Variable Page Installing and Configuring Sun StorEdge Volume Manager Before YouInstall Sun StorEdge Volume Manager Page Caution Installing the VolumeManager Software Mounting the CD-ROM Manually Running the Installation Setting up the Volume Manager Environment Setting Default Volume Creation Note Dealing with Stale Boot Disks Enabling Recovery Behavior and Boot Disk Detection Initializing the VolumeManager Note Setting up Boot Disks Note Setting up Other Disks Note To Add a New Disk Note Configuring Storage Boot Disk Aliases Note Index A B C D F G H I L O P R S T