Sun Microsystems V490 manual Prtconf Command

CODE EXAMPLE 6-7

prtconf Command

The prtconf command displays the Solaris device tree. This tree includes all the devices probed by OpenBoot firmware, as well as additional devices, like individual disks, that only the operating system software “knows” about. The output of

prtconf also includes the total amount of system memory.shows an excerpt of prtconf output (edited to save space).

System Configuration: Sun Microsystems sun4u

Memory size: 1024 Megabytes

System Peripherals (Software Nodes):

SUNW,Sun-Fire-V490

packages (driver not attached) SUNW,builtin-drivers (driver not attached)

...

SUNW,UltraSPARC-IV (driver not attached) memory-controller, instance #3

pci, instance #0 SUNW,qlc, instance #5

fp (driver not attached) disk (driver not attached)

...

pci, instance #2 ebus, instance #0

flashprom (driver not attached) bbc (driver not attached) power (driver not attached) i2c, instance #1

fru, instance #17

CODE EXAMPLE 6-7 prtconf Command Output

The prtconf command’s -poption produces output similar to the OpenBoot show-devscommand (see “show-devsCommand” on page 92). This output lists only those devices compiled by the system firmware.

prtdiag Command

The prtdiag command displays a table of diagnostic information that summarizes the status of system components.

94 Sun Fire V490 Server Administration Guide • August 2004