Sun Microsystems V490 manual How to Reconfigure a Device Manually, Do one of the following

2.To effect the changes immediately, type:

ok reset-all

Note – To immediately effect the changes, you can also power cycle the system using the front panel Power button

How to Reconfigure a Device Manually

Before You Begin

You can use the OpenBoot asr-enablecommand to reconfigure any device that you previously deconfigured with asr-disable. For background information, see

■“About Manually Configuring Devices” on page 59

What to Do

1.At the system ok prompt, type:

ok asr-enabledevice-identifier

where the device-identifieris one of the following:

■Any full physical device path as reported by the OpenBoot show-devscommand

■Any valid device alias as reported by the OpenBoot devalias command

■An identifier for a device or a range of devices given in “Reference for Device Identifiers” on page 61

2.Do one of the following:

■If you are reconfiguring a processor, power cycle the system using the front panel Power button.

■If you are reconfiguring any other device, type:

ok reset-all

Chapter 9 Configuring System Firmware 163