2.At the Main# prompt, type cfg to display the Configuration menu and prompt (Configuration#).

>> Main# cfg [Configuration Menu]

sys

-

System-wide parameter menu

port

-

Port configuration menu

ip

-

IP addressing menu

vlan

-

VLAN configuration menu

stp

-

Spanning Tree menu

snmp

-

SNMP menu

setup

-

Step by step configuration set up

dump

- Dump current configuration to script file

>> Configuration#

3.Type the following to disable autonegotiation on a GigaSwift Ethernet port. Replace portnumber with the Ethernet port used by the adapter.

>>Configuration# /port portnumber/auto off

4.Type the following to apply and save your changes.

>>Configuration# apply

>>Configuration# save

Refer to the switch documentation for further configuration instructions.

To Set Autonegotiation to off for Other Noncompliant Network Equipment

If your network equipment does not support autonegotiation, you can set autonegotiation to off on the GigaSwift Ethernet (ce) device.

1.Set the following GigaSwift Ethernet driver parameters to values according to the documentation that shipped with your switch:

adv-1000fdx-cap

adv-1000hdx-cap

adv-ampause-cap

adv-pause-cap

Appendix B Diagnostic Software and Troubleshooting Issues 77

Page 101
Image 101
Sun Microsystems X1150A manual Type the following to apply and save your changes, Adv-pause-cap